Dell OptiPlex 9020 SFF vs. HP ProDesk 600 G6 Microtower

Comparison and Differences

Dell_OptiPlex_9020_SFF.jpg case front and back pannelHP_ProDesk_600_G6_Microtower.jpg case front and back pannel
Model
Form factorSmallMini Tower
CPU optionsIntel Gen4 i3/i5/i7; Intel Gen10 i3/i5/i7/i9; Celeron; Pentium;
ChipsetQ87Q470
Dedicated GPU *GeForce GTX 1650 Low ProfileGeForce GTX 1660 Super
RAMDIMM DDR3-1600 DIMM DDR4-3200
RAM slots44
RAM speed1600 MT/s3200 MT/s
RAM max32 GB128 GB
USB ports(4x) USB-A 3.0; (6x) USB-A 2.0; USB-C 3.1; (2x)USB-A 3.1; (5x)USB-A 3.0; (2x)USB-A 2.0;
Video ports(2x) DisplayPort 1.2; VGA;(2x) DisplayPort:
Other portsRJ45; Hdph; Mic; Line-Out; Line-In; Serial; (2x) PS2; RJ45; Headset; Line-Out;
Optional portsN.A.DP1.4/ HDMI2.0a/ VGA/ USB-C(DP1.4)/ (2x)USB-A 3.0/ LAN/ Serial; Serial/Thunderbolt3; SD card reader;
SATA ports34
PCI slotsPCIe 3.0 x16; PCIe x16 (wired x4); PCIe 3.0 x16; (2x) PCIe 3.0 x1; PCIe 3.0 x16 (wired x4);
M.2 slotsN.A.(2x) M.2 2280/2230 M-key (PCIe x4); M.2 2230 (WiFi/BT);
Drive bays2.5/3.5in; 5.25in(slim)(2x) 2.5in; 3.5in; 5.25in; 5.25in (slim)
PSU 255 W180/260/550 W
Weight6.00 kg (13.22 lb)5.0 kg (11.02 lb)
Released20132020
Manuallinklink
Price**Check PriceCheck Price

** As an Amazon associate we earn from qualifying purchases.
* Dedicated GPU warning: Check if your particular power supply model has enough power. Additionally some PSUs don't come with an auxiliary PCIe power connector and you may need to buy a SATA to PCIe power adapter.

Differences between Dell OptiPlex 9020 SFF and HP ProDesk 600 G6 Microtower

If you are looking for a more modern desktop, then you should go with the HP ProDesk 600 G6 Microtower which was released in 2020. The Dell OptiPlex 9020 SFF is older and entered production in 2013.

If you are looking for the smaller form factor the Dell OptiPlex 9020 SFF is the right one for you. It is smaller than the HP ProDesk 600 G6 Microtower and will fit more easily under your desk.

Processor

Usually the newer the generation of the CPU, the better the performance and efficiency is. If your budget allows it, you should go with the HP ProDesk 600 G6 Microtower as it is running a newer generation CPU. This is not to say that Dell OptiPlex 9020 SFF is bad - it can still run some powerful CPUs, albeit being an older generation.

Memory

Both models have have equal amount of ram slots (4 RAM). Usually two RAM slots are more than enough for most cases. However, the count should be taken into account when planning how much and what combination of RAM you are going to need for your system.

The HP ProDesk 600 G6 Microtower is using the faster 3200 MT/s RAM. The Dell OptiPlex 9020 SFF is slower by supporting RAM speeds of up to 1600 MT/s. Additionally, if you will be needing a lot of RAM, better go for the HP ProDesk 600 G6 Microtower as it has the ability to run 128 GB of RAM. The Dell OptiPlex 9020 SFF can do a bit less at max 32 GB. Most of the times, this should be sufficient for the majority of users.

Ports

Both models have the same amount of USB ports for total count of 10. If this is not enough, using a USB hub is always a viable option. What is nice about the HP ProDesk 600 G6 Microtower, is that it has 3 USB 3.1 port(s) which allows transfer of up to 10Gb/s. Unfortunately, the Dell OptiPlex 9020 SFF has no such port, thus restricting your transfer speeds significantly. For people who want to use external drives on regular basis, this might be an issue.

The DisplayPort is usually the more popular video port used with desktops and laptops, while the HDMI is used predominantly in consumer electronics. That's why, it is good to see that both of the models come with a DisplayPort.

None of the models has an HDMI port. If your monitor supports only the HDMI interface, you will need to buy an adapter. Such adapters are cheap so nothing to worry about.

SATA ports are placed on the system board and it is where you connect your HDD, SSD and Optical Disk Drives. More SATA slots will allow you to have more drives running at the same time. In this regard the HP ProDesk 600 G6 Microtower is better equipped as it comes with 4 SATA slot(s), while the Dell OptiPlex 9020 SFF has 3 slot(s).

If you want the fastest transfer speeds for your SSD, an M.2 interface is crucial. Thus, if the M.2 SSD slot is a mandatory requirement for you, go with the HP ProDesk 600 G6 Microtower. Sadly, the Dell OptiPlex 9020 SFF has no such slot, and you will be forced to use the SATA interface instead.

Make sure that the available M.2 slot supports the PCIe (also called NVMe) interface. This is important as there are M.2 slots which support only the inferior SATA III interface. For comparison, the SATA III interface has max speeds of 6Gb/s, while the PCIe 3.0 x4 will support speeds up to 32Gb/s!

Power Supply

Having a Power Supply Unit with high power rating is important, if you are going to use components which require extra power. The Dell OptiPlex 9020 SFF comes with a decent 255 Watt PSU, but the HP ProDesk 600 G6 Microtower has a more powerful one rated at 550 Watts. Choosing either one depends on your specific requirements and use case. Also don't forget that some models might have more than one PSU option - try to always get the most powerful one, especially if you plan to upgrade to a powerful GPU.

Motherboard

Dell_OptiPlex_9020_SFF_motherboard.jpg motherboard layoutHP_ProDesk_600_G6_Microtower_motherboard.jpg motherboard layout