Fujitsu Esprimo D9010 vs. Fujitsu Esprimo P756

Comparison and Differences

Fujitsu_Esprimo_D9010.jpg case front and back pannelFujitsu_Esprimo_P756.jpg case front and back pannel
Model
Form factorSmallMini Tower
CPU optionsIntel Gen10 i3/i5/i7/i9Intel Gen6 i3/i5/i7; Pentium; Celeron
ChipsetQ470Q150
Dedicated GPU *Radeon RX 6400 Low ProfileGeForce GTX 1650 Super
RAMUDIMM DDR4-2933UDIMM DDR4-2133
RAM slots44
RAM speed2933 MT/s2133 MT/s
RAM max128 GB64 GB
USB ports(2x) USB-A 3.0; (4x) USB-A 2.0; (4x) USB-A 3.1; USB-C 3.1(4x) USB-A 3.0; (6x) USB-A 2.0
Video ports(2x) DisplayPort 1.2(2x) DisplayPort 1.2; DVI
Other portsRJ45; Headset, Line in; Line outRJ45; Headphones; (2x) Mic; Line in; Line out; PS/2; Serial
Optional portsSerial; Parallel; PS/2; VGA; DVI; USB-C 3.1 (DP support 60W/15W)Serial; Parallel; VGA; eSATA
SATA ports45
PCI slotsPCIe 3.0 x16; PCIe 3.0 x16 (wired x4)PCIe 3.0 x16; (2x) PCIe 2.0 x1; PCIe 2.0 x16 (wired x4)
M.2 slots(2x) M.2 2280/2230 M-key (PCIe 3.0 x4, NVMe); M.2 2230 (WiFi/BT)M.2 2280/2230 M-key (PCIe 3.0 x4, SSD)
Drive bays3.5in; 2.5in; (2x) 5.25 inch slim(4x) 3.5in; (2x) 5.25 inch
PSU280/300 W280 W
Weight8.00 kg (17.64 lb)11.00 kg (24.25 lb)
Released20202016
Manuallinklink
Price**Check PriceCheck Price

** As an Amazon associate we earn from qualifying purchases.
* Dedicated GPU warning: Check if your particular power supply model has enough power. Additionally some PSUs don't come with an auxiliary PCIe power connector and you may need to buy a SATA to PCIe power adapter.

Differences between Fujitsu Esprimo D9010 and Fujitsu Esprimo P756

If you are looking for a more modern desktop, then you should go with the Fujitsu Esprimo D9010 which was released in 2020. The Fujitsu Esprimo P756 is older and entered production in 2016.

If you are looking for the smaller form factor the Fujitsu Esprimo D9010 is the right one for you. It is smaller than the Fujitsu Esprimo P756 and will fit more easily under your desk.

Processor

Usually the newer the generation of the CPU, the better the performance and efficiency is. If your budget allows it, you should go with the Fujitsu Esprimo D9010 as it is running a newer generation CPU. This is not to say that Fujitsu Esprimo P756 is bad - it can still run some powerful CPUs, albeit being an older generation.

Memory

Both models have have equal amount of ram slots (4 RAM). Usually two RAM slots are more than enough for most cases. However, the count should be taken into account when planning how much and what combination of RAM you are going to need for your system.

The Fujitsu Esprimo D9010 is using the faster 2933 MT/s RAM. The Fujitsu Esprimo P756 is slower by supporting RAM speeds of up to 2133 MT/s. Additionally, if you will be needing a lot of RAM, better go for the Fujitsu Esprimo D9010 as it has the ability to run 128 GB of RAM. The Fujitsu Esprimo P756 can do a bit less at max 64 GB. Most of the times, this should be sufficient for the majority of users.

Ports

In total the Fujitsu Esprimo D9010 has 11 USB ports. The Fujitsu Esprimo P756 is inferior in this regard and packs 10 USB ports. In any case, if you miss USB ports, you can always purchase a USB hub. What is nice about the Fujitsu Esprimo D9010, is that it has 4 USB 3.1 port(s) which allows transfer of up to 10Gb/s. Unfortunately, the Fujitsu Esprimo P756 has no such port, thus restricting your transfer speeds significantly. For people who want to use external drives on regular basis, this might be an issue.

The DisplayPort is usually the more popular video port used with desktops and laptops, while the HDMI is used predominantly in consumer electronics. That's why, it is good to see that both of the models come with a DisplayPort.

None of the models has an HDMI port. If your monitor supports only the HDMI interface, you will need to buy an adapter. Such adapters are cheap so nothing to worry about.

SATA ports are placed on the system board and it is where you connect your HDD, SSD and Optical Disk Drives. More SATA slots will allow you to have more drives running at the same time. In this regard the Fujitsu Esprimo P756 is better equipped as it comes with 5 SATA slot(s), while the Fujitsu Esprimo D9010 has 4 slot(s).

An M.2 SSD can be several times faster than a SATA one. Thus, we are happy to see that both models support the M.2 interface. However, the Fujitsu Esprimo D9010 has 1 M.2 slots while the Fujitsu Esprimo P756 comes with just 1.

Make sure that the available M.2 slot supports the PCIe (also called NVMe) interface. This is important as there are M.2 slots which support only the inferior SATA III interface. For comparison, the SATA III interface has max speeds of 6Gb/s, while the PCIe 3.0 x4 will support speeds up to 32Gb/s!

Power Supply

Having a Power Supply Unit with high power rating is important, if you are going to use components which require extra power. The Fujitsu Esprimo P756 comes with a decent 280 Watt PSU, but the Fujitsu Esprimo D9010 has a more powerful one rated at 300 Watts. Choosing either one depends on your specific requirements and use case. Also don't forget that some models might have more than one PSU option - try to always get the most powerful one, especially if you plan to upgrade to a powerful GPU.

Motherboard

Fujitsu_Esprimo_D9010_motherboard.jpg motherboard layoutFujitsu_Esprimo_P756_motherboard.jpg motherboard layout