Dell OptiPlex 790 DT vs. Fujitsu Esprimo D7011

Comparison and Differences

Dell_OptiPlex_790_DT.jpg case front and back pannelFujitsu_Esprimo_D7011.jpg case front and back pannel
Model
Form factorDesktopSmall
CPU optionsIntel Gen2 i3/i5/i7; Celeron; Pentium;Intel Gen10&11 i3/i5/i7/i9
ChipsetQ65B560
Dedicated GPU *GeForce GTX 1650 Low ProfileRadeon RX 6400 Low Profile
RAMDIMM DDR3-1333UDIMM DDR4-3200
RAM slots24
RAM speed1333 MT/s3200 MT/s
RAM max16 GB128 GB
USB ports(10x)USB-A 2.0; (2x) USB-A 3.0; (7x) USB-A 2.0; USB-A 3.1; USB-C 3.2
Video portsDisplayPort 1.2; VGA;(2x) DisplayPort 1.4
Other portsRJ45; Hdph; (2x) Mic; Line-Out; Line-In; PS2/COM; Serial; Parallel;RJ45; Headset, Line in; Line out
Optional portsN.A.Serial; PS/2; VGA; DVI; USB-C 3.1 (DP support 60W/15W)
SATA ports35
PCI slotsPCIe 2.0 x16; PCIe 2.0 x4; PCIe 2.0 x1;PCIe 4.0 x16; PCIe 3.0 x1; PCIe 3.0 x16 (wired x4)
M.2 slotsN.A.(2x) M.2 2280/2230 M-key (PCIe 4.0/3.0 x4, NVMe); M.2 2230 (WiFi/BT)
Drive bays3.5in; 2.5in; 5.25in;3.5in; 2.5in; (2x) 5.25 inch slim
PSU250 W280/300 W
Weight7.56 kg (16.67 lb)8.00 kg (17.64 lb)
Released20112021
Manuallinklink
Price**Check PriceCheck Price

** As an Amazon associate we earn from qualifying purchases.
* Dedicated GPU warning: Check if your particular power supply model has enough power. Additionally some PSUs don't come with an auxiliary PCIe power connector and you may need to buy a SATA to PCIe power adapter.

Differences between Dell OptiPlex 790 DT and Fujitsu Esprimo D7011

If you are looking for a more modern desktop, then you should go with the Fujitsu Esprimo D7011 which was released in 2021. The Dell OptiPlex 790 DT is older and entered production in 2011.

If you are looking for the smaller form factor the Fujitsu Esprimo D7011 is the right one for you. It is smaller than the Dell OptiPlex 790 DT and will fit more easily under your desk.

Processor

Usually the newer the generation of the CPU, the better the performance and efficiency is. If your budget allows it, you should go with the Fujitsu Esprimo D7011 as it is running a newer generation CPU. This is not to say that Dell OptiPlex 790 DT is bad - it can still run some powerful CPUs, albeit being an older generation.

Memory

The Fujitsu Esprimo D7011 has 4 RAM slots while the Dell OptiPlex 790 DT has only 2 slot(s). This is not something to worry about. Just make sure you take it into consideration when planning how much RAM you are going to use.

The Fujitsu Esprimo D7011 is using the faster 3200 MT/s RAM. The Dell OptiPlex 790 DT is slower by supporting RAM speeds of up to 1333 MT/s. Additionally, if you will be needing a lot of RAM, better go for the Fujitsu Esprimo D7011 as it has the ability to run 128 GB of RAM. The Dell OptiPlex 790 DT can do a bit less at max 16 GB. Most of the times, this should be sufficient for the majority of users.

Ports

In total the Fujitsu Esprimo D7011 has 11 USB ports. The Dell OptiPlex 790 DT is inferior in this regard and packs 8 USB ports. In any case, if you miss USB ports, you can always purchase a USB hub. What is nice about the Fujitsu Esprimo D7011, is that it has 1 USB 3.1 port(s) which allows transfer of up to 10Gb/s. Unfortunately, the Dell OptiPlex 790 DT has no such port, thus restricting your transfer speeds significantly. For people who want to use external drives on regular basis, this might be an issue.

The DisplayPort is usually the more popular video port used with desktops and laptops, while the HDMI is used predominantly in consumer electronics. That's why, it is good to see that both of the models come with a DisplayPort.

None of the models has an HDMI port. If your monitor supports only the HDMI interface, you will need to buy an adapter. Such adapters are cheap so nothing to worry about.

SATA ports are placed on the system board and it is where you connect your HDD, SSD and Optical Disk Drives. More SATA slots will allow you to have more drives running at the same time. In this regard the Fujitsu Esprimo D7011 is better equipped as it comes with 5 SATA slot(s), while the Dell OptiPlex 790 DT has 3 slot(s).

If you want the fastest transfer speeds for your SSD, an M.2 interface is crucial. Thus, if the M.2 SSD slot is a mandatory requirement for you, go with the Fujitsu Esprimo D7011. Sadly, the Dell OptiPlex 790 DT has no such slot, and you will be forced to use the SATA interface instead.

Make sure that the available M.2 slot supports the PCIe (also called NVMe) interface. This is important as there are M.2 slots which support only the inferior SATA III interface. For comparison, the SATA III interface has max speeds of 6Gb/s, while the PCIe 3.0 x4 will support speeds up to 32Gb/s!

Power Supply

Having a Power Supply Unit with high power rating is important, if you are going to use components which require extra power. The Dell OptiPlex 790 DT comes with a decent 250 Watt PSU, but the Fujitsu Esprimo D7011 has a more powerful one rated at 300 Watts. Choosing either one depends on your specific requirements and use case. Also don't forget that some models might have more than one PSU option - try to always get the most powerful one, especially if you plan to upgrade to a powerful GPU.

Motherboard

Dell_OptiPlex_790_DT_motherboard.jpg motherboard layoutFujitsu_Esprimo_D7011_motherboard.jpg motherboard layout