Dell OptiPlex 9010 DT vs. Fujitsu Esprimo D7010

Comparison and Differences

Dell_OptiPlex_9010_DT.jpg case front and back pannelFujitsu_Esprimo_D7010.jpg case front and back pannel
Model
Form factorDesktopSmall
CPU optionsIntel Gen2&3 i3/i5/i7; Celeron; Pentium;Intel Gen10 i3/i5/i7/i9; Pentium; Celeron
ChipsetQ77B460
Dedicated GPU *GeForce GTX 1650 Low ProfileRadeon RX 6400 Low Profile
RAMDIMM DDR3-1333/1600 UDIMM DDR4-2933
RAM slots44
RAM speed1600 MT/s2933 MT/s
RAM max32 GB128 GB
USB ports(4x) USB-A 3.0; (6x) USB-A 2.0; (6x) USB-A 3.0; (4x) USB-A 2.0; USB-A 3.1; USB-C 3.1
Video ports(2x) DisplayPort 1.1; VGA;(2x) DisplayPort 1.2
Other portsSerial; (2x) PS2; RJ45; Hdph; Mic; Line-Out; Line-In; RJ45; Headset, Line in; Line out
Optional portsN.A.Serial; Parallel; PS/2; VGA; DVI; USB-C 3.1 (DP support 60W/15W)
SATA ports34
PCI slotsPCIe 3.0 x16; PCIe 2.0 x1; PCI; PCIe 2.0 x16 (wired x4);PCIe 3.0 x16; PCIe 3.0 x16 (wired x4)
M.2 slotsN.A.M.2 2280/2230 M-key (PCIe 3.0 x4, NVMe)
Drive bays3.5in/2.5in; 2.5in; 5.25in;(3x) 3.5in; 2.5in; (2x) 5.25 inch
PSU250 W280/300 W
Weight7.9 kg (17.38 lb)8.00 kg (17.64 lb)
Released20122020
Manuallinklink
Price**Check PriceCheck Price

** As an Amazon associate we earn from qualifying purchases.
* Dedicated GPU warning: Check if your particular power supply model has enough power. Additionally some PSUs don't come with an auxiliary PCIe power connector and you may need to buy a SATA to PCIe power adapter.

Differences between Dell OptiPlex 9010 DT and Fujitsu Esprimo D7010

If you are looking for a more modern desktop, then you should go with the Fujitsu Esprimo D7010 which was released in 2020. The Dell OptiPlex 9010 DT is older and entered production in 2012.

If you are looking for the smaller form factor the Fujitsu Esprimo D7010 is the right one for you. It is smaller than the Dell OptiPlex 9010 DT and will fit more easily under your desk.

Processor

Usually the newer the generation of the CPU, the better the performance and efficiency is. If your budget allows it, you should go with the Fujitsu Esprimo D7010 as it is running a newer generation CPU. This is not to say that Dell OptiPlex 9010 DT is bad - it can still run some powerful CPUs, albeit being an older generation.

Memory

Both models have have equal amount of ram slots (4 RAM). Usually two RAM slots are more than enough for most cases. However, the count should be taken into account when planning how much and what combination of RAM you are going to need for your system.

The Fujitsu Esprimo D7010 is using the faster 2933 MT/s RAM. The Dell OptiPlex 9010 DT is slower by supporting RAM speeds of up to 1600 MT/s. Additionally, if you will be needing a lot of RAM, better go for the Fujitsu Esprimo D7010 as it has the ability to run 128 GB of RAM. The Dell OptiPlex 9010 DT can do a bit less at max 32 GB. Most of the times, this should be sufficient for the majority of users.

Ports

In total the Fujitsu Esprimo D7010 has 12 USB ports. The Dell OptiPlex 9010 DT is inferior in this regard and packs 10 USB ports. In any case, if you miss USB ports, you can always purchase a USB hub. What is nice about the Fujitsu Esprimo D7010, is that it has 2 USB 3.1 port(s) which allows transfer of up to 10Gb/s. Unfortunately, the Dell OptiPlex 9010 DT has no such port, thus restricting your transfer speeds significantly. For people who want to use external drives on regular basis, this might be an issue.

The DisplayPort is usually the more popular video port used with desktops and laptops, while the HDMI is used predominantly in consumer electronics. That's why, it is good to see that both of the models come with a DisplayPort.

None of the models has an HDMI port. If your monitor supports only the HDMI interface, you will need to buy an adapter. Such adapters are cheap so nothing to worry about.

SATA ports are placed on the system board and it is where you connect your HDD, SSD and Optical Disk Drives. More SATA slots will allow you to have more drives running at the same time. In this regard the Fujitsu Esprimo D7010 is better equipped as it comes with 4 SATA slot(s), while the Dell OptiPlex 9010 DT has 3 slot(s).

If you want the fastest transfer speeds for your SSD, an M.2 interface is crucial. Thus, if the M.2 SSD slot is a mandatory requirement for you, go with the Fujitsu Esprimo D7010. Sadly, the Dell OptiPlex 9010 DT has no such slot, and you will be forced to use the SATA interface instead.

Make sure that the available M.2 slot supports the PCIe (also called NVMe) interface. This is important as there are M.2 slots which support only the inferior SATA III interface. For comparison, the SATA III interface has max speeds of 6Gb/s, while the PCIe 3.0 x4 will support speeds up to 32Gb/s!

Power Supply

Having a Power Supply Unit with high power rating is important, if you are going to use components which require extra power. The Dell OptiPlex 9010 DT comes with a decent 250 Watt PSU, but the Fujitsu Esprimo D7010 has a more powerful one rated at 300 Watts. Choosing either one depends on your specific requirements and use case. Also don't forget that some models might have more than one PSU option - try to always get the most powerful one, especially if you plan to upgrade to a powerful GPU.

Motherboard

Dell_OptiPlex_9010_DT_motherboard.jpg motherboard layoutFujitsu_Esprimo_D7010_motherboard.jpg motherboard layout