Fujitsu Esprimo D556 vs. HP ProDesk 600 G6 Microtower

Comparison and Differences

Fujitsu_Esprimo_D556.jpg case front and back pannelHP_ProDesk_600_G6_Microtower.jpg case front and back pannel
Model
Form factorSmallMini Tower
CPU optionsIntel Gen6 i3/i5/i7; Pentium; CeleronIntel Gen10 i3/i5/i7/i9; Celeron; Pentium;
ChipsetH110Q470
Dedicated GPU *Radeon RX 6400 Low ProfileGeForce GTX 1660 Super
RAMUDIMM DDR4-2133DIMM DDR4-3200
RAM slots24
RAM speed2133 MT/s3200 MT/s
RAM max32 GB128 GB
USB ports(4x) USB-A 3.0; (6x) USB-A 2.0USB-C 3.1; (2x)USB-A 3.1; (5x)USB-A 3.0; (2x)USB-A 2.0;
Video portsDisplayPort 1.2; DVI(2x) DisplayPort:
Other portsRJ45; Headphones; Mic; Line in; Line out; PS/2RJ45; Headset; Line-Out;
Optional portsVGA; eSATADP1.4/ HDMI2.0a/ VGA/ USB-C(DP1.4)/ (2x)USB-A 3.0/ LAN/ Serial; Serial/Thunderbolt3; SD card reader;
SATA ports34
PCI slotsPCIe 3.0 x16; PCIe 2.0 x1; PCIe 2.0 x16 (wired x4)PCIe 3.0 x16; (2x) PCIe 3.0 x1; PCIe 3.0 x16 (wired x4);
M.2 slotsM.2 2280/2230 M-key (PCIe 2.0 x2, SSD)(2x) M.2 2280/2230 M-key (PCIe x4); M.2 2230 (WiFi/BT);
Drive bays(3x) 3.5in; 5.25 inch(2x) 2.5in; 3.5in; 5.25in; 5.25in (slim)
PSU280 W180/260/550 W
Weight8.00 kg (17.64 lb)5.0 kg (11.02 lb)
Released20152020
Manuallinklink
Price**Check PriceCheck Price

** As an Amazon associate we earn from qualifying purchases.
* Dedicated GPU warning: Check if your particular power supply model has enough power. Additionally some PSUs don't come with an auxiliary PCIe power connector and you may need to buy a SATA to PCIe power adapter.

Differences between Fujitsu Esprimo D556 and HP ProDesk 600 G6 Microtower

If you are looking for a more modern desktop, then you should go with the HP ProDesk 600 G6 Microtower which was released in 2020. The Fujitsu Esprimo D556 is older and entered production in 2015.

If you are looking for the smaller form factor the Fujitsu Esprimo D556 is the right one for you. It is smaller than the HP ProDesk 600 G6 Microtower and will fit more easily under your desk.

Processor

Usually the newer the generation of the CPU, the better the performance and efficiency is. If your budget allows it, you should go with the HP ProDesk 600 G6 Microtower as it is running a newer generation CPU. This is not to say that Fujitsu Esprimo D556 is bad - it can still run some powerful CPUs, albeit being an older generation.

Memory

The HP ProDesk 600 G6 Microtower has 4 RAM slots while the Fujitsu Esprimo D556 has only 2 slot(s). This is not something to worry about. Just make sure you take it into consideration when planning how much RAM you are going to use.

The HP ProDesk 600 G6 Microtower is using the faster 3200 MT/s RAM. The Fujitsu Esprimo D556 is slower by supporting RAM speeds of up to 2133 MT/s. Additionally, if you will be needing a lot of RAM, better go for the HP ProDesk 600 G6 Microtower as it has the ability to run 128 GB of RAM. The Fujitsu Esprimo D556 can do a bit less at max 32 GB. Most of the times, this should be sufficient for the majority of users.

Ports

Both models have the same amount of USB ports for total count of 10. If this is not enough, using a USB hub is always a viable option. What is nice about the HP ProDesk 600 G6 Microtower, is that it has 3 USB 3.1 port(s) which allows transfer of up to 10Gb/s. Unfortunately, the Fujitsu Esprimo D556 has no such port, thus restricting your transfer speeds significantly. For people who want to use external drives on regular basis, this might be an issue.

DisplayPort is crucial for any desktop machine. It is good to see that both models are featuring DisplayPorts. However, the HP ProDesk 600 G6 Microtower comes with 2 ports, while the Fujitsu Esprimo D556 has only 1. If you are planning to use multiple monitors, the HP ProDesk 600 G6 Microtower is the better choice.

None of the models has an HDMI port. If your monitor supports only the HDMI interface, you will need to buy an adapter. Such adapters are cheap so nothing to worry about.

SATA ports are placed on the system board and it is where you connect your HDD, SSD and Optical Disk Drives. More SATA slots will allow you to have more drives running at the same time. In this regard the HP ProDesk 600 G6 Microtower is better equipped as it comes with 4 SATA slot(s), while the Fujitsu Esprimo D556 has 3 slot(s).

An M.2 SSD can be several times faster than a SATA one. Thus, we are happy to see that both models support the M.2 interface. However, the HP ProDesk 600 G6 Microtower has 1 M.2 slots while the Fujitsu Esprimo D556 comes with just 1.

Make sure that the available M.2 slot supports the PCIe (also called NVMe) interface. This is important as there are M.2 slots which support only the inferior SATA III interface. For comparison, the SATA III interface has max speeds of 6Gb/s, while the PCIe 3.0 x4 will support speeds up to 32Gb/s!

Power Supply

Having a Power Supply Unit with high power rating is important, if you are going to use components which require extra power. The Fujitsu Esprimo D556 comes with a decent 280 Watt PSU, but the HP ProDesk 600 G6 Microtower has a more powerful one rated at 550 Watts. Choosing either one depends on your specific requirements and use case. Also don't forget that some models might have more than one PSU option - try to always get the most powerful one, especially if you plan to upgrade to a powerful GPU.

Motherboard

Fujitsu_Esprimo_D556_motherboard.jpg motherboard layoutHP_ProDesk_600_G6_Microtower_motherboard.jpg motherboard layout