Dell OptiPlex 5000 SFF vs. Fujitsu Esprimo P958

Comparison and Differences

Dell_OptiPlex_5000_SFF.jpg case front and back pannelFujitsu_Esprimo_P958.jpg case front and back pannel
Model
Form factorSmallMini Tower
CPU optionsIntel Gen 12 i3/i5/i7; PentiumIntel Gen8&9 i3/i5/i7
ChipsetQ670Q370
Dedicated GPU *AMD Radeon RX 6400 Low ProfileGeForce GTX 1650 Super
RAMDIMM DDR4-3200UDIMM DDR4-2666
RAM slots44
RAM speed3200 MT/s2666 MT/s
RAM max128 GB64 GB
USB ports(4x) USB-A 2.0; (5x) USB-A 3.0; USB-C 3.1;(3x) USB-A 3.0; (5x) USB-A 2.0; (3x) USB-C 3.1; USB-C 3.1
Video ports(2x) Display Port 1.4a;(2x) DisplayPort 1.2; DVI
Other portsRJ45; Audio; Line-Out/In;RJ45; Headphones; Mic; Line in; Line out; PS/2
Optional portsHDMI 2.0b/Displayport/VGA/PS2/serial/USB Type-C; SD-card slotSerial; Parallel; VGA; eSATA
SATA ports35
PCI slotsPCIe 4.0 x16; PCIe 3.0 x4;PCIe 3.0 x16; (2x) PCIe 3.0 x1; PCIe 3.0 x16 (wired x4)
M.2 slotsM.2 2230/2280 (PCIe 4.0 x4, NVMe); M.2 2230 (WiFi/BT) M.2 2280/2230 M-key (PCIe 3.0 x4, NVMe); M.2 2230 (WiFi/BT)
Drive bays3.5in; 2.5in;(3x) 3.5in; 2.5in; (2x) 5.25 inch
PSU240/260/300 W210/280 W
Weight5.16 kg (11.39 lb)7.40 kg (16.31 lb)
Released20222018
Manuallinklink
Price**Check PriceCheck Price

** As an Amazon associate we earn from qualifying purchases.
* Dedicated GPU warning: Check if your particular power supply model has enough power. Additionally some PSUs don't come with an auxiliary PCIe power connector and you may need to buy a SATA to PCIe power adapter.

Differences between Dell OptiPlex 5000 SFF and Fujitsu Esprimo P958

If you are looking for a more modern desktop, then you should go with the Dell OptiPlex 5000 SFF which was released in 2022. The Fujitsu Esprimo P958 is older and entered production in 2018.

If you are looking for the smaller form factor the Dell OptiPlex 5000 SFF is the right one for you. It is smaller than the Fujitsu Esprimo P958 and will fit more easily under your desk.

Processor

Usually the newer the generation of the CPU, the better the performance and efficiency is. If your budget allows it, you should go with the Dell OptiPlex 5000 SFF as it is running a newer generation CPU. This is not to say that Fujitsu Esprimo P958 is bad - it can still run some powerful CPUs, albeit being an older generation.

Memory

Both models have have equal amount of ram slots (4 RAM). Usually two RAM slots are more than enough for most cases. However, the count should be taken into account when planning how much and what combination of RAM you are going to need for your system.

The Dell OptiPlex 5000 SFF is using the faster 3200 MT/s RAM. The Fujitsu Esprimo P958 is slower by supporting RAM speeds of up to 2666 MT/s. Additionally, if you will be needing a lot of RAM, better go for the Dell OptiPlex 5000 SFF as it has the ability to run 128 GB of RAM. The Fujitsu Esprimo P958 can do a bit less at max 64 GB. Most of the times, this should be sufficient for the majority of users.

Ports

In total the Fujitsu Esprimo P958 has 13 USB ports. The Dell OptiPlex 5000 SFF is inferior in this regard and packs 10 USB ports. In any case, if you miss USB ports, you can always purchase a USB hub. It's great that both of the models have USB 3.1 ports which will allow you to exchange data with your peripherals at up to 10Gb/s. But if you need maximum connectivity, go with the Fujitsu Esprimo P958 as it has 4 USB3.1 ports (the Dell OptiPlex 5000 SFF has 1).

The DisplayPort is usually the more popular video port used with desktops and laptops, while the HDMI is used predominantly in consumer electronics. That's why, it is good to see that both of the models come with a DisplayPort.

None of the models has an HDMI port. If your monitor supports only the HDMI interface, you will need to buy an adapter. Such adapters are cheap so nothing to worry about.

SATA ports are placed on the system board and it is where you connect your HDD, SSD and Optical Disk Drives. More SATA slots will allow you to have more drives running at the same time. In this regard the Fujitsu Esprimo P958 is better equipped as it comes with 5 SATA slot(s), while the Dell OptiPlex 5000 SFF has 3 slot(s).

When your goal is to have the fastest SSD transfer speeds, an M.2 interface is crucial. Thus, it is good that both models have M.2 SSD slots. Today M.2 SSDs are not much more expensive than the average SATA drives, so it really does not make sense to invest in SATA drives anymore.

Make sure that the available M.2 slot supports the PCIe (also called NVMe) interface. This is important as there are M.2 slots which support only the inferior SATA III interface. For comparison, the SATA III interface has max speeds of 6Gb/s, while the PCIe 3.0 x4 will support speeds up to 32Gb/s!

Power Supply

Having a Power Supply Unit with high power rating is important, if you are going to use components which require extra power. The Fujitsu Esprimo P958 comes with a decent 280 Watt PSU, but the Dell OptiPlex 5000 SFF has a more powerful one rated at 300 Watts. Choosing either one depends on your specific requirements and use case. Also don't forget that some models might have more than one PSU option - try to always get the most powerful one, especially if you plan to upgrade to a powerful GPU.

Motherboard

Dell_OptiPlex_5000_SFF_motherboard.jpg motherboard layoutFujitsu_Esprimo_P958_motherboard.jpg motherboard layout