Dell OptiPlex 3090 Tower vs. Fujitsu Esprimo D7012

Comparison and Differences

Dell_OptiPlex_3090_Tower.jpg case front and back pannelFujitsu_Esprimo_D7012.jpg case front and back pannel
Model
Form factorMini TowerSmall
CPU optionsIntel Gen 10 i3/i5/i7/i9; PentiumIntel Gen12 i3/i5/i7/i9; Pentium
ChipsetQ470Q670
Dedicated GPU *GeForce GTX 1650Radeon RX 6400 Low Profile
RAMDIMM DDR4-2666UDIMM DDR4-3200
RAM slots24
RAM speed2666 MT/s3200 MT/s
RAM max64 GB128 GB
USB ports(4x) USB-A 2.0; (4x) USB-A 3.0;(2x) USB-A 3.0; (7x) USB-A 2.0; USB-A 3.1; USB-C 3.2
Video portsDisplay Port 1.4a; HDMI 1.4b;(2x) DisplayPort 1.4
Other portsRJ45; Audio; Line-Out/In;RJ45; Headset, Line in; Line out
Optional portsHDMI 2.0b/Displayport/VGA;HDMI 2.1; DP 1.4a; DVI; VGA; Parallel; Serial; Thunderbolt 4; (2x) USB-C 3.1 (DP support 60W/15W)
SATA ports34
PCI slotsPCIe 3.0 x16; (2x) PCIe 3.0 x1;PCIe 4.0 x16; PCIe 3.0 x1; PCIe 3.0 x16 (wired x4)
M.2 slotsM.2 2230/2280 (PCIe 4.0 x4, NVMe); M.2 2230 (WiFi/BT) (2x) M.2 2280/2230 M-key (PCIe 4.0 x4, NVMe); M.2 2230 (WiFi/BT)
Drive bays3.5in; 2.5in; 5.25in (slim);3.5in; 2.5in; (2x) 5.25 inch
PSU260 W280/300 W
Weight6.50 kg (14.33 lb)6.00 kg (13.20 lb)
Released20212022
Manuallinklink
Price**Check PriceCheck Price

** As an Amazon associate we earn from qualifying purchases.
* Dedicated GPU warning: Check if your particular power supply model has enough power. Additionally some PSUs don't come with an auxiliary PCIe power connector and you may need to buy a SATA to PCIe power adapter.

Differences between Dell OptiPlex 3090 Tower and Fujitsu Esprimo D7012

If you are looking for a more modern desktop, then you should go with the Fujitsu Esprimo D7012 which was released in 2022. The Dell OptiPlex 3090 Tower is older and entered production in 2021.

If you are looking for the smaller form factor the Fujitsu Esprimo D7012 is the right one for you. It is smaller than the Dell OptiPlex 3090 Tower and will fit more easily under your desk.

Processor

Usually the newer the generation of the CPU, the better the performance and efficiency is. If your budget allows it, you should go with the Fujitsu Esprimo D7012 as it is running a newer generation CPU. This is not to say that Dell OptiPlex 3090 Tower is bad - it can still run some powerful CPUs, albeit being an older generation.

Memory

The Fujitsu Esprimo D7012 has 4 RAM slots while the Dell OptiPlex 3090 Tower has only 2 slot(s). This is not something to worry about. Just make sure you take it into consideration when planning how much RAM you are going to use.

The Fujitsu Esprimo D7012 is using the faster 3200 MT/s RAM. The Dell OptiPlex 3090 Tower is slower by supporting RAM speeds of up to 2666 MT/s. Additionally, if you will be needing a lot of RAM, better go for the Fujitsu Esprimo D7012 as it has the ability to run 128 GB of RAM. The Dell OptiPlex 3090 Tower can do a bit less at max 64 GB. Most of the times, this should be sufficient for the majority of users.

Ports

In total the Fujitsu Esprimo D7012 has 11 USB ports. The Dell OptiPlex 3090 Tower is inferior in this regard and packs 8 USB ports. In any case, if you miss USB ports, you can always purchase a USB hub. What is nice about the Fujitsu Esprimo D7012, is that it has 1 USB 3.1 port(s) which allows transfer of up to 10Gb/s. Unfortunately, the Dell OptiPlex 3090 Tower has no such port, thus restricting your transfer speeds significantly. For people who want to use external drives on regular basis, this might be an issue.

The DisplayPort is usually the more popular video port used with desktops and laptops, while the HDMI is used predominantly in consumer electronics. That's why, it is good to see that both of the models come with a DisplayPort.

None of the models has an HDMI port. If your monitor supports only the HDMI interface, you will need to buy an adapter. Such adapters are cheap so nothing to worry about.

SATA ports are placed on the system board and it is where you connect your HDD, SSD and Optical Disk Drives. More SATA slots will allow you to have more drives running at the same time. In this regard the Fujitsu Esprimo D7012 is better equipped as it comes with 4 SATA slot(s), while the Dell OptiPlex 3090 Tower has 3 slot(s).

An M.2 SSD can be several times faster than a SATA one. Thus, we are happy to see that both models support the M.2 interface. However, the Fujitsu Esprimo D7012 has 1 M.2 slots while the Dell OptiPlex 3090 Tower comes with just 1.

Make sure that the available M.2 slot supports the PCIe (also called NVMe) interface. This is important as there are M.2 slots which support only the inferior SATA III interface. For comparison, the SATA III interface has max speeds of 6Gb/s, while the PCIe 3.0 x4 will support speeds up to 32Gb/s!

Power Supply

Having a Power Supply Unit with high power rating is important, if you are going to use components which require extra power. The Dell OptiPlex 3090 Tower comes with a decent 260 Watt PSU, but the Fujitsu Esprimo D7012 has a more powerful one rated at 300 Watts. Choosing either one depends on your specific requirements and use case. Also don't forget that some models might have more than one PSU option - try to always get the most powerful one, especially if you plan to upgrade to a powerful GPU.

Motherboard

Dell_OptiPlex_3090_Tower_motherboard.jpg motherboard layoutFujitsu_Esprimo_D7012_motherboard.jpg motherboard layout