Alienware Aurora R3 vs. HP ProDesk 600 G5 Microtower

Comparison and Differences

Alienware_Aurora_R3.jpg case front and back pannelHP_ProDesk_600_G5_Microtower.jpg case front and back pannel
Model
Form factorMid TowerMini Tower
CPU optionsIntel Gen2 i3/i5/i7;Intel Gen8&9 i3/i5/i7; Celeron; Pentium;
ChipsetP67Q370
Dedicated GPU *GeForce GTX 1650 SuperGeForce GTX 1660 Super
RAMDIMM DDR3-1333/1866DIMM DDR4-2666
RAM slots44
RAM speed1866 MT/s2666 MT/s
RAM max32 GB128 GB
USB ports(5x) USB 3.0 Type A; (8x) USB-A 2.0;USB-C 3.1; (4x)USB-A 3.1; (2x)USB-A 3.0; (4x)USB-A 2.0;
Video portsN/A(2x) DisplayPort:
Other portsRJ45; Headset; Line-Out; Line-In; S/PDFI optical/analog;RJ45; Headset; Line-Out; Line-In;
Optional portsN.A.DP1.2/HDMI2.0/VGA/USB-C(DP); Serial; SD card reader;
SATA ports44
PCI slots(x2) PCIe 3.0 x16; (x2) PCIe 3.0 x1;PCIe 3.0 x16; (2x) PCIe 3.0 x1; PCIe 3.0 x16 (wired x4);
M.2 slotsN.A.M.2 2280/2230 M-key (PCIe x4); M.2 2230 (WiFi/BT);
Drive bays(4x) 3.25in; (3x) 5.25in;(2x) 2.5in; 3.5in; 5.25in; 5.25in (slim)
PSU525/875 W250/400 W
Weight22.09 kg (48.7 lb)7.14 kg (15.74 lb)
Released20112018
Manuallinklink
Price**Check PriceCheck Price

** As an Amazon associate we earn from qualifying purchases.
* Dedicated GPU warning: Check if your particular power supply model has enough power. Additionally some PSUs don't come with an auxiliary PCIe power connector and you may need to buy a SATA to PCIe power adapter.

Differences between Alienware Aurora R3 and HP ProDesk 600 G5 Microtower

If you are looking for a more modern desktop, then you should go with the HP ProDesk 600 G5 Microtower which was released in 2018. The Alienware Aurora R3 is older and entered production in 2011.

If you are looking for the smaller form factor the Alienware Aurora R3 is the right one for you. It is smaller than the HP ProDesk 600 G5 Microtower and will fit more easily under your desk.

Processor

Usually the newer the generation of the CPU, the better the performance and efficiency is. If your budget allows it, you should go with the HP ProDesk 600 G5 Microtower as it is running a newer generation CPU. This is not to say that Alienware Aurora R3 is bad - it can still run some powerful CPUs, albeit being an older generation.

Memory

Both models have have equal amount of ram slots (4 RAM). Usually two RAM slots are more than enough for most cases. However, the count should be taken into account when planning how much and what combination of RAM you are going to need for your system.

The HP ProDesk 600 G5 Microtower is using the faster 2666 MT/s RAM. The Alienware Aurora R3 is slower by supporting RAM speeds of up to 1866 MT/s. Additionally, if you will be needing a lot of RAM, better go for the HP ProDesk 600 G5 Microtower as it has the ability to run 128 GB of RAM. The Alienware Aurora R3 can do a bit less at max 32 GB. Most of the times, this should be sufficient for the majority of users.

Ports

In total the Alienware Aurora R3 has 13 USB ports. The HP ProDesk 600 G5 Microtower is inferior in this regard and packs 11 USB ports. In any case, if you miss USB ports, you can always purchase a USB hub. What is nice about the HP ProDesk 600 G5 Microtower, is that it has 5 USB 3.1 port(s) which allows transfer of up to 10Gb/s. Unfortunately, the Alienware Aurora R3 has no such port, thus restricting your transfer speeds significantly. For people who want to use external drives on regular basis, this might be an issue.

Unfortunately, only the HP ProDesk 600 G5 Microtower has a DisplayPort. The Alienware Aurora R3 does not have one? Don't worry though, nowadays video adapters are cheap and you can get almost any combination of conversion types.

None of the models has an HDMI port. If your monitor supports only the HDMI interface, you will need to buy an adapter. Such adapters are cheap so nothing to worry about.

SATA slots are located on the motherboard and it is where SSD, HDD and Optical Disk Drives are connected. Each of the two models being compared have 4 SATA slot(s). Keep in mind that having too few SATA slots might limit your options for connecting additional memory drives.

If you want the fastest transfer speeds for your SSD, an M.2 interface is crucial. Thus, if the M.2 SSD slot is a mandatory requirement for you, go with the HP ProDesk 600 G5 Microtower. Sadly, the Alienware Aurora R3 has no such slot, and you will be forced to use the SATA interface instead.

Make sure that the available M.2 slot supports the PCIe (also called NVMe) interface. This is important as there are M.2 slots which support only the inferior SATA III interface. For comparison, the SATA III interface has max speeds of 6Gb/s, while the PCIe 3.0 x4 will support speeds up to 32Gb/s!

Power Supply

Having a Power Supply Unit with high power rating is important, if you are going to use components which require extra power. The HP ProDesk 600 G5 Microtower comes with a decent 400 Watt PSU, but the Alienware Aurora R3 has a more powerful one rated at 875 Watts. Choosing either one depends on your specific requirements and use case. Also don't forget that some models might have more than one PSU option - try to always get the most powerful one, especially if you plan to upgrade to a powerful GPU.

Motherboard

Alienware_Aurora_R3_motherboard.jpg motherboard layoutHP_ProDesk_600_G5_Microtower_motherboard.jpg motherboard layout