Acer Veriton X2670g vs. HP ProDesk 400 G1 Microtower

Comparison and Differences

Acer_Veriton_X2670g.jpg case front and back pannelHP_ProDesk_400_G1_Microtower.jpg case front and back pannel
Model
Form factorSmallMini Tower
CPU optionsIntel Gen10 i3/i5/i7/i9; Pentium; CeleronIntel Gen4 i3/i5/i7; Celeron; Pentium;
ChipsetB460H81
Dedicated GPU *Radeon RX 6400 Low ProfileGeForce GTX 1660 Super
RAMUDIMM DDR4-2933DIMM DDR3-1600
RAM slots22
RAM speed2933 MT/s1600 MT/s
RAM max32 GB16 GB
USB ports(2x) USB-A 3.0; (2x) USB-A 2.0; (4x) USB-A 3.1; USB-C 3.1(2x)USB-A 3.0; (6x)USB-A 2.0;
Video portsDisplayPort 1.2; HDMI 1.4; VGADVI-D; VGA;
Other portsRJ45; (2x) Mic, Speaker; Line in; Line out; PS/2 ports; SerialRJ45; Hdph; Mic; Line-Out; Line-In; Serial; (2x) PS2;
Optional portsCard readerMedia card reader (USB 2.0); Serial; Parallel;
SATA ports34
PCI slotsPCIe 2.0 x16; PCIe 2.0 x16 (wired x4); PCIe 2.0 x1; PCIPCIe x16; (3x) PCIe x1;
M.2 slotsM.2 2280/2230 M-key (PCIe 3.0 x4, NVMe); M.2 2230 (WiFi/BT)N.A.
Drive bays(2x) 3.5in; 5.25 inch slim(3x) 3.5in; (2x) 5.25in
PSU180/300 W300 W
Weight7.00 kg (15.40 lb)7.1 kg (15.75 lb)
Released20202013
Manuallinklink
Price**Check PriceCheck Price

** As an Amazon associate we earn from qualifying purchases.
* Dedicated GPU warning: Check if your particular power supply model has enough power. Additionally some PSUs don't come with an auxiliary PCIe power connector and you may need to buy a SATA to PCIe power adapter.

Differences between Acer Veriton X2670g and HP ProDesk 400 G1 Microtower

If you are looking for a more modern desktop, then you should go with the Acer Veriton X2670g which was released in 2020. The HP ProDesk 400 G1 Microtower is older and entered production in 2013.

If you are looking for the smaller form factor the Acer Veriton X2670g is the right one for you. It is smaller than the HP ProDesk 400 G1 Microtower and will fit more easily under your desk.

Processor

Usually the newer the generation of the CPU, the better the performance and efficiency is. If your budget allows it, you should go with the Acer Veriton X2670g as it is running a newer generation CPU. This is not to say that HP ProDesk 400 G1 Microtower is bad - it can still run some powerful CPUs, albeit being an older generation.

Memory

Both models have have equal amount of ram slots (2 RAM). Usually two RAM slots are more than enough for most cases. However, the count should be taken into account when planning how much and what combination of RAM you are going to need for your system.

The Acer Veriton X2670g is using the faster 2933 MT/s RAM. The HP ProDesk 400 G1 Microtower is slower by supporting RAM speeds of up to 1600 MT/s. Additionally, if you will be needing a lot of RAM, better go for the Acer Veriton X2670g as it has the ability to run 32 GB of RAM. The HP ProDesk 400 G1 Microtower can do a bit less at max 16 GB. Most of the times, this should be sufficient for the majority of users.

Ports

In total the HP ProDesk 400 G1 Microtower has 8 USB ports. The Acer Veriton X2670g is inferior in this regard and packs 7 USB ports. In any case, if you miss USB ports, you can always purchase a USB hub. None of the desktop models has a USB 3.1 port (10Gb/s), so if you need a fast connection to your peripherals, like external Solid State Drive, you will need to look elsewhere.

Unfortunately, only the Acer Veriton X2670g has a DisplayPort. The HP ProDesk 400 G1 Microtower does not have one? Don't worry though, nowadays video adapters are cheap and you can get almost any combination of conversion types.

The Acer Veriton X2670g comes with an HDMI port, while the HP ProDesk 400 G1 Microtower does not support the interface. Of course missing HDMI port is something that can be easily fixed with a good adapter (e.g. DisplayPort to HDMI).

SATA ports are placed on the system board and it is where you connect your HDD, SSD and Optical Disk Drives. More SATA slots will allow you to have more drives running at the same time. In this regard the HP ProDesk 400 G1 Microtower is better equipped as it comes with 4 SATA slot(s), while the Acer Veriton X2670g has 3 slot(s).

If you want the fastest transfer speeds for your SSD, an M.2 interface is crucial. Thus, if the M.2 SSD slot is a mandatory requirement for you, go with the Acer Veriton X2670g. Sadly, the HP ProDesk 400 G1 Microtower has no such slot, and you will be forced to use the SATA interface instead.

Make sure that the available M.2 slot supports the PCIe (also called NVMe) interface. This is important as there are M.2 slots which support only the inferior SATA III interface. For comparison, the SATA III interface has max speeds of 6Gb/s, while the PCIe 3.0 x4 will support speeds up to 32Gb/s!

Power Supply

Looking at the Power Supply Unit (PSU) of the two models we don't see any differences. For either of them you get a maximum power of 300 Watts. However be careful, many models have more than one power supply option. When buying your computer, it is a good idea to get a version with the most powerful PSU. This will potentially allow you to upgrade to a more powerful GPU for example.

Motherboard

Acer_Veriton_X2670g_motherboard.jpg motherboard layoutHP_ProDesk_400_G1_Microtower_motherboard.jpg motherboard layout